Effect of printing parameters on impact energy absorption of additively manufactured hierarchical structures

Abstract

Purpose

This study aims to examine how the thickness of layers and printing speed impact the energy absorption capacity of honeycomb structures through drop-weight experiments. In addition, the effect of printing orientation on the resulting microstructure and mechanical performance was targeted to be examined.

Design/methodology/approach

In this paper, after manufacturing test specimens using fused deposition modeling technique with three distinct layer thicknesses (0.16 mm, 0.20 mm and 0.28 mm) and printing speeds (40 mm/min, 50 mm/min and 70 mm/min), drop weight tests were carried out. Then to see the effect of printing orientation on mechanical performance, three-point-bending tests were performed and damage mechanisms were comparatively examined through scanning electron microscopy.

Findings

An increase in layer thickness from 0.16 mm to 0.28 mm resulted in a notable 37% decrease in the impact resistance of the printed part. In addition, increasing the printing speed from 50 to 70 mm/min reduced the energy absorption capacity of the printed part by approximately 36.5%. Moreover, in terms of printing direction, transversely printed specimens showed 10% lower flexural strength than longitudinally printed specimens. Finally, scanning electron microscopy (SEM) observation showed that internal defects were more prominent in transversely printed specimens, resulting in premature failure. Furthermore, delamination was also detected in transversely printed specimens as another damage mechanism accelerating material failure.

Originality/value

It is seen that the effect of printing parameters on the fundamental mechanical properties including tensile strength, strain at break, ductility and elastic modulus were studied by various researchers. However, to the best of authors’ knowledge, the effect of printing speed and layer thickness on the energy absorption of polylactic acid based hexagonal honeycomb was not encountered. In addition, in-depth SEM analysis to discover the influence of printing direction significantly contributes to the literature.

Citation

Irez, A.B. and Bilgen Bagci, M. (2024), "Effect of printing parameters on impact energy absorption of additively manufactured hierarchical structures", Rapid Prototyping Journal, Vol. 30 No. 6, pp. 1161-1169. https://doi.org/10.1108/RPJ-08-2023-0294